Attaching the Patient
2-8 Getting Started
Ge
tti
ng St
a
rte
d
Starting
Monitoring
The patient's vital signs are now appearing on the screen. The pre-
configured default settings for the parameters and screen display, that
were set up at installation or have been stored in the module
(“Parameter Settings Transfer”), are active.
If you want to make changes to the screen display see the section
“Configuring the System”
. If you want to make changes to the
parameter settings see the individual parameter sections.
Switch the system alarms ON (by pressing the
key so that
the Alarm Suspend lamp goes out). The patient is now being monitored.
Screen
Messages
Two types of messages appear at the top of the display screen:
•
Prompt messages - these instruct the user to perform an action
•
Status messages - these give information about the current
situation. For instance:
“sync output not available, plug-in ECG module''
Suspend
Summary of Contents for M1165
