49
User Manual
Problems when faxing or printing
Faxes are of poor quality.
Change the resolution setting to
F
or
f
.
Check the document or set a higher contrast with func-
tion 47 (see chapter
Fax & Copy
/ Contrast).
Test the fax machine by making a copy. If your copy
is faultless the correspondent’s fax machine might be
defective.
Call service if necessary.
Your fax or your recipient’s fax machine produces black
lines when printing.
Clean the scanner with a cloth (see Care).
Test the fax machine by making a copy. If your copy
is faultless the correspondent’s fax machine might be
defective.
Call service if necessary.
Copy is blank.
Load the document with the printed side up.
Call service if necessary.
Problems with the connection
Your fax machine rings once, then there is a moment of
silence and another ring signal after that.
Th
is is entirely normal. After the fi rst ring signal the fax
machine takes over the call. When the fax machine has
recognised that the incoming call is a telephone corre-
spondence, the fax machine will continue to ring.
NO
CONNECTION
or
REDIAL
FAILED
Try later or draw your fax partner’s attention to a pos-
sible installation fault.
NO
LOOP
CURRENT
Check the installation of your fax machine.
When you place a call on the cordless telephone you do
not hear the dial tone.
Connect your telephone cable to the socket on your fax
machine identifi ed with
LINE
.
BUSY
or
fax transmissions are constantly interrupted.
Try to send the fax manually: Press
z
and dial the fax
number. If the recipient is using an automatic answer-
ing device, wait until you hear a tone after the pre-re-
corded message. Press
START
.
You cannot receive any faxes.
Set the number of ringing signals for the answering ma-
chine or the total number of ringing signals with func-
tion 31 or 32 to lower than fi ve.
On accepting a call on the cordless telephone you hear
a tone or silence.
You are receiving a fax. At the fax machine: Press
START
. At an additional telephone: press
*
and
5
.
Replace the handset.
EXTERNAL
PHONE
Th
e red lamp
v
fl ashes.
Th
is is not a fault.
You are now using an additional tel-
ephone.
Problems with the cordless telephone
Th
ere is no dial tone on the cordless telephone.
Place the cordless telephone on the base station (fax
machine) and wait at least 12 hours until the batteries
are fully recharged.
You cannot hear a dial tone even though the cordless
telephone has been charged on the base station (fax ma-
chine) for longer than 12 hours.
Get closer to the fax machine so you are within the
maximum range.
Please contact your dealer for new batteries of the type
AAA.
Summary of Contents for Magic 3-2
Page 1: ...Easy Install User Manual ...