5
Philips/Magnavox Components
The DSS remote control can control up to six
different components and is already
pre-pro-
grammed
for use with newer Philips/
Magnavox audio/video equipment. Unless
you want to change a factory setting,skip the
programming instructions and simply start
using your new remote control.
Programming Other Components
To control component brands other than
Philips/Magnavox,you’ll need to perform the
following steps to manually program the
DSS with codes listed under
Manufacturer’s
Codes
on pages 15 through 19. Or as alterna-
tive, you can use the
Auto Scan
feature, on
page 6, to program your component codes.
The following chart lists the remote control’s
component keys and what type of device
each key will control:
Key
Programmed To Control
TV
TV
VCR
VCR, DVD or LD Player
CBL
Cable Box
AUD
Amplifier, Tuner, Misc.Audio,
or CD Player
DSS
Digital Satellite System
CD
CD Player,Amplifier, Tuner, or
Misc.Audio
NOTE: If you want the component keys to
control other types of devices, you’ll need to
reassign the component keys. See page 7.
IMPORTANT: Please completely read and
review the following steps before proceeding.We
recommend highlighting the codes (starting on
page 15) for the brands you wish to program or
writing them down in the supplied chart.
Setup Codes For My Components
TV
VCR
CBL
DSS
CD
DVD
AUDIO
LD
OTHER
To Manually Program The Remote Control:
NOTE: To program a TV/VCR Combo, skip
these instructions and follow the steps on the
next page.
1.
Manually turn on a component
(e.g.,TV, VCR,etc.) and,if applic-
able, insert media (e.g., cassette).
2.
On the remote con-
trol, press a compo-
nent key once (e.g.,
TV
,
VCR
,
CBL
,
AUD
,
DSS
, or
CD
).
3.
Press and hold
SET
(approx.
5 seconds) until the red light
blinks twice, then release
SET
.
4.
Enter the first four-digit code for
your brand of component. If
performed correctly, the red
light will blink twice.
5.
Aim the remote control at the
component and press
POWER
once. It should turn off. If it does
not respond, repeat steps 2 and
3, trying each code for your
brand until you find one that
works. If it still does not work,
try using
Auto Scan
(on page 6)
to program your component.
6.
Repeat steps 1 through 5 for each
component you want to program
into the DSS remote control.
NOTES: Press each key within 10 seconds of
the previous entry. Otherwise, the remote con-
trol will exit the programming mode.
If you press
SET
at any time (except during
step 3), the remote control will exit the pro-
gramming mode without saving your entries.
You will have to start with step 1 to begin pro-
gramming again.
PROGRAMMING YOUR REMOTE CONTROL
REM400 Manual Engl 12/28/99 12:01 PM Page 5
