14
English
Preparations
Setting the clock
After connecting the set to the power supply, set
the clock first.
Important!
To set clock in the Eco Power mode,
press and hold STANDBY-ON/ ECO
POWER
B
on the set for 3 seconds or
more to switch to normal standby mode
first before proceeding with the
procedures below.
1
Press
CLOCK
on the remote control to view
clock time.
➜
The display shows the set time.
➜
00
:
00
displays by default if you have not set
the clock.
2
Press
CLOCK
once again.
➜
The hours digits start flashing.
3
Hold down or press
ALBUM/PRESET
+/-
on
the set repeatedly to set the hours.
4
Press
CLOCK
to confirm.
➜
The minutes digits start flashing
5
Hold down or press
ALBUM/PRESET
+/-
on
the set repeatedly to set the minutes.
6
Press
CLOCK
to confirm.
– To exit without storing the clock setting press
9
.
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by pressing
one of the source select keys on the remote
control (for example CD, TUNER).
3
Then select the desired function (for example
ÉÅ
,
à
,
á
).
Remove the plastic protective sheet
Replacing battery (lithium
CR2025) into the remote control
1
Press the slot on the battery compartment.
2
Pull out the battery compartment.
3
Replace a new battery and fully inser t the
battery compartment back to the original
position.
1
2
3
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
P001-P029_MCB279_05_Eng
2008.5.8, 16:23
14
Summary of Contents for MCB279
Page 3: ...3 3 4 5 2 1 6 8 7 9 0 ...
