30
English
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
●
The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1
In standby mode, press and hold
TIMER
for
more than three seconds.
➜
"
SET TIMER
" is displayed briefly. Then, the
hour digits flash on the display panel.
2
Turn the
VOLUME
control on the front panel
or press
/-
on the remote to set
the hours and press
TIMER
to confirm.
➜
The minute digits flash on the display panel.
3
Turn the
VOLUME
control on the front panel
or press
/-
on the remote to set
the minutes and press
TIMER
to confirm.
➜
"
ON
" or "
OFF
" flashes.
4
Turn the
VOLUME
control on the front panel
or press
/-
on the remote to
activate or deactivate the timer and press
TIMER
to complete the setting.
➜
Display shows
if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press
SLEEP
on the remote control repeatedly
to select a preset time.
➜
The selections are as follows (time in
minutes):
00
™
10
™
20
™
30
™
40
™
50
™
60
™
70
™
80
™
90
™
00
➜
"
SLEEP XX
" is displayed. "
XX
" is the time in
minutes.
2
When you reach the desired length of time, stop
pressing the
SLEEP
button.
To deactivate the sleep timer
●
Press
SLEEP
repeatedly until "
00
" is displayed,
or press
STANDBY ON
y
.
DISPLAY/ST
pg001-pg035_MCD190_21-Eng
2005.7.27, 11:25
30
