22
English
Preparations
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the Remote Control
1
3
2
1
Open the battery compartment.
2
Insert two AAA batteries following the
indications (+/-) inside the compar tment.
3
Close the cover.
Using the Remote Control to operate
the Player
1
Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.
2
Do not put any objects between
the Remote Control and the
DVD Player while operating the
DVD Player.
CAUTION!
–
Remove batteries if they are
exhausted or if the Remote Control is
not being used for a long time.
–
Do not use old and new or different
types of batteries in combination.
–
Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
1
Go to Standby mode.
2
Press and hold
CLOCK
on the remote.
➜
“
CLOCK SET
” is displayed briefly. Then, the
hour digits flash on the display screen.
3
Press
VOLUME -/+
(
VOL +/-
on the remote)
to set the hours.
4
Press
CLOCK
again.
➜
The minute digits flash on the display screen.
5
Press
VOLUME -/+
(
VOL +/-
on the remote)
to set the minutes.
6
Press
CLOCK
to confirm the clock setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
pg001-pg025_MCD288-37-Eng-A
2006.3.15, 16:51
22
