12
English
Using Composite Video jack
1
Use the composite video cable (yellow) to
connect the system's
VIDEO OUT
jack to the
video input jack (or labelled as A/V In, Video In,
Composite or Baseband) on the TV set.
2
To hear the TV channels through this DVD
system, use the audio cables (white/red-not
supplied) to connect
AUX IN
jacks to the
corresponding AUDIO OUT jacks on the TV.
Connections
Step 2: Connecting speakers
1
Connect the two front speakers to the
SPEAKERS (8
Ω
) terminals with two speaker
cables. Right speaker to “R” and left speaker to
“L”, red wire to “+” and silver wire to “-”. Fully
insert the stripped por tion of the speaker wire
into the terminal as shown.
A
B
2
Connect the passive subwoofer to the
WOOFER OUT (8
Ω
) terminal with the supplied
subwoofer cable by matching the plug types.
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Step 3: Connecting the control
cable
●
Connect the serial port marked “CONTROL
CABLE” at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.
Step 4: Connecting TV
IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
B
pg 001-041_MCD718_37
2006.4.13, 17:52
12
Summary of Contents for MCD718
Page 3: ...3 ...
Page 5: ...5 English Français Español Index English 7 Français 46 Español 85 ...
Page 43: ...43 ...