36
English
Radio Reception
Tuning to radio stations
1
Press
ECO POWER/STANDBY-ON
B
(
B
on the remote) to switch on the last selected
source.
2
Press
SOURCE
(
TUNER
on the remote) to
select TUNER mode.
3
Press
TUNER
on the remote again to select
the desired band: FM or AM.
4
Press and hold
¡
/
™
(
CH +/-
¡
/
™
on the
remote) until the frequency indication starts to
change, then release.
➜
The system automatically tunes to the next
strong radio station.
●
To tune to a weak station, press
¡
/
™
(
CH +/-
à
/
á
on the remote) briefly and repeatedly
until an optimal reception is found.
5
Repeat Step 4 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Automatic progamming
●
Press
PROG
on the remote for more than two
seconds to activate programming.
➜
All available stations are programmed.
Manual progamming
1
Tune to your desired radio station (refer to
“Tuning to radio stations”).
2
Press
PROG
on the remote.
➜
”
PROG
” icon flashes.
3
Press
or
PRESET-/
9
(or
CH +/-
(
¡
/
™
) on the remote) to select the desired
preset number.
➜
If “
PROG
” icon goes off before you select the
desired preset number, press
PROG
on the
remote.
4
Press
PROG
on the remote again to store the
radio station.
●
Repeat steps 1-4 to store other radio stations.
Other Functions
Listening to preset radio stations
●
In tuner mode, press
or
PRESET-/
9
(or
CH +/-
(
¡
/
™
) on the remote) to select
the desired preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1
In Standby mode, press and hold
CLOCK
on
the remote until the time flashes on the display.
➜
”
CLOCK SET
” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn
VOLUME -/+
clockwise or anticlockwise
or press
/-
on the remote to set
the hours.
3
Press
CLOCK
to confirm.
➜
The minute digits flash on the display screen.
4
Turn
VOLUME -/+
clockwise or anticlockwise
or press
/-
on the remote to set
the minutes.
5
Press
CLOCK
again to confirm the clock
setting.
Notes:
– This system only supports 12-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
Setting sleep/wake-up timer
Sleep timer setting
In power-on mode
, the sleep setting enables
the system to switch to standby mode
automatically at a preset time.
1
In power-on mode, press
SLEEP/TIMER
on
the remote repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
00
➜
10
➜
20
➜
30
➜
40
➜
50
➜
60
➜
70
➜
80
➜
90
➜
00
pg 001-041_MCD718_37
2006.4.13, 17:52
36
Summary of Contents for MCD718
Page 3: ...3 ...
Page 5: ...5 English Français Español Index English 7 Français 46 Español 85 ...
Page 43: ...43 ...
