16
Insert the battery with its polarities (+/–
signs) aligned as indicated.
Replace the battery.
Aim the remote control directly at the
sensor on the front of the unit.
&DQQRWGLVSOD\VRPHÀOHVLQ86%GHYLFH
7KHQXPEHURIIROGHUVRUÀOHVLQWKH86%
device has exceeded a certain limit. This
phenomenon is not a malfunction.
7KHIRUPDWVRIWKHVHÀOHVDUHQRW
supported.
USB device not supported
The USB device is incompatible with the
unit. Try another one.
Poor radio reception
Increase the distance between the unit
and your TV or VCR.
Fully extend and adjust the FM antenna.
Clock/timer setting erased
Power has been interrupted or the power
cord has been disconnected.
Reset the clock/timer.
Clock disappeared
The unit switched to eco power standby
mode. Press to display the clock.
Timer does not work
Set the clock correctly.
Switch on the timer.
9 Troubleshooting
Warning
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site www.
philips.com/welcome. When you contact Philips,
ensure that the apparatus is nearby and the
model number and serial number are available.
No power
Ensure that the AC power plug of the
unit is connected properly.
Ensure that there is power at the AC
outlet.
To save power, the unit switches to
standby automatically 15 minutes after
a play reaches the end and no control is
operated.
No sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power
plug, then turn on the unit again.
No disc detected
Insert a disc.
Check if the disc is inserted with the print
side facing inward.
Wait until the moisture condensation at
the lens has cleared.
Replace or clean the disc.
8VHDÀQDOL]HG&'RUFRUUHFWIRUPDWGLVF
Remote control does not work
%HIRUHSUHVVLQJDQ\IXQFWLRQEXWWRQÀUVW
select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the unit.
EN
