English
25
The system does not react when buttons
are pressed.
Sound cannot be heard or is of poor
quality.
The left and right sound outputs are
reversed.
The remote control does not function
properly.
The timer is not working.
The Clock/Timer setting is erased.
Some files on the USB device are not
displayed.
“
DEVICE NOT SUPPORTED
” scrolls on the
display.
✔
Remove and reconnect the AC power plug and
switch on the system again.
✔
Adjust the volume.
✔
Disconnect the headphones.
✔
Check that the speakers are connected correctly.
✔
Check if the stripped speaker wire is clamped.
✔
Make sure the MP3-CD was recorded within
32-256 kbps bit rate with sampling frequencies
at 48 kHz, 44.1 kHz or 32 kHz.
✔
Check the speaker connections and location.
✔
Select the source (CD or TUNER, for example)
before pressing the function button (
É
,
í
,
ë
).
✔
Reduce the distance between the remote
control and the system.
✔
Insert the batteries with their polarities
(+/– signs) aligned as indicated.
✔
Replace the batteries.
✔
Point the remote control directly toward
IR sensor on the front of the system.
✔
Set the clock correctly.
✔
Press TIMER to switch on the timer.
✔
Power has been interrupted or the AC power
cord has been disconnected. Reset the clock/
timer.
✔
Check if the number of folders exceeds 99 or
the number of titles exceeds 500.
✔
Remove the USB mass storage device or select
another source.
Problem
Solution
Troubleshooting
pg 001-025_MCM394_22-Eng
2008.1.8, 9:14 AM
25
