12
Demonstrate the unit’s
features
1
In the standby mode, press until
“DEMO ON” is displayed.
Available features are displayed one
»
by one.
To turn off the demonstration, press
•
again.
Adjust brightness of display
panel
Press
DIM
repeatedly to select different
brightness levels.
Turn on or off LED light
1
In power-on mode, press and hold
DIM
to turn on or off the LED light at the
bottom of the unit and at the volume
knob.
Turn on
1
Press .
The unit switches to the last selected
»
source.
Switch to standby mode
To switch the system to Eco Power Standby
mode:
In standby mode, press and hold for 2
seconds.
»
[ECO POWER]
(Eco power) scrolls on
the display, then the backlight turns off.
Note
If you are not going to use the remote control
•
for a long time, remove the batteries.
Do not use old and new or different types of
•
batteries in combination.
Batteries contain chemical substances, so they
•
should be disposed of properly.
Set clock
1
In standby mode, press
CLOCK
for three
seconds to activate clock setting mode.
»
[CLOCK SET]
scrolls on the display,
then the time format
[24H]
or
[12H]
is displayed.
2
Press
VOL +/-
to select 24H or 12H, then
press
CLOCK
to confirm.
The hour digits begin to blink.
»
3
Press
VOL +/-
to set hour, then press
CLOCK
again.
The minute digits begin to blink.
»
4
Press
VOL +/-
to set minute.
5
Press
CLOCK
to confirm the clock
setting.
Note
If no button is pressed in 90 seconds, the
•
system exits clock setting mode automatically.
a
b
c
EN