English
xxxxx
15
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service centre.
Problem
Solution
CD OPERATION
“
no cd
”
is displayed.
–
Insert a disc.
–
Check if the disc is inserted upside down.
–
Wait until the moisture condensation at the lens
has cleared.
–
Replace or clean the disc, see “Maintenance”.
–
Use a finalised CD-RW or CD-R.
RADIO RECEPTION
Radio reception is poor.
–
If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
–
Increase the distance between the Micro HiFi
System and your TV or VCR.
GENERAL
The system does not react when buttons
–
Remove and reconnect the AC power plug and
are pressed.
switch on the system again.
Sound cannot be heard or is of poor
–
Adjust the volume.
quality.
–
Disconnect the headphones.
–
Check that the speakers are connected correctly.
–
Check if the stripped speaker wire is clamped.
The left and right sound outputs are
–
Check the speaker connections and location.
reversed.
The remote control does not function
–
Select the source (CD or TUNER, for example)
properly.
before pressing the function button (
É
,
í
,
ë
).
–
Reduce the distance between the remote control
and the system.
–
Insert the batteries with their polarities
(+/– signs) aligned as indicated.
–
Replace the batteries.
–
Point the remote control directly toward
IR sensor on the front of the system.
The timer is not working.
–
Set the clock correctly.
–
Press
TIMER
to switch on the timer.
–
If a recording is in progress, stop the recording.
The Clock/Timer setting is erased.
–
Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
MC108B_79_Eng
14/2/07, 11:33
15
