ROW
MX740
Cinema Receiver System
Technical Specifications
Connections
•
Audio inputs/outputs
: 4 input sources, 2 output connections
- CD
: in
- CDR/Tape
: in/out
- TV
: in
- VCR
: in/out
- Headphone
: 6.3 mm
•
Speaker connections suitable for speakers
≥
6 Ohm (rear
≥
3 ohm)
- left, right, center
: click-fit connection
- rear left, right
: click-fit connection
•
Miscellaneous connections
- Cinema Link system control bus: 2
- center pre-out
: 2
- mains socket
: 1 (maximum 100W)
- AM antenna
: loop type
- FM antenna
: coaxial 75 Ohm
Amplifier
•
Power output stereo mode 6 Ohms, DIN, 1kHz, 0.7% THD
- left, right
: 2 x 50 W
•
Power output surround mode 6 Ohms, 1 KHz, 0.7% THD
- left, right
: 2 x 50 W
- center
: 50 W
- rear left, right
: 50 W
•
Amplifier characteristics
- total harmonic distortion
: 0.05 % (1 kHz, 5W output)
- power bandwidth (D<0.7%)
: 20 Hz – 20 kHz, -3 dB
- frequency response (linear)
: 10 Hz – 30 kHz,
±
1 dB
- signal-to-noise ratio (weighted) : > 85 dBA, (acc. IHF, 1kOhm)
- stereo separation
: > 55 dB, 1 kHz
•
Controls
- bass
: 100 Hz, (-9dB … +9dB)
- treble
: 10 kHz, (-9dB … +9dB)
- loudness
: +6 dB (100Hz,-30dB), +3 dB (10kHz,-30dB)
•
Surround
- modes
: Pro-Logic, Center Phantom, 3-Stereo, Hall
- delay
: 15 to 30ms (steps of 5ms)
•
Audio input sensitivity
- CD
: 250 mV / 47 kOhms
- CDR/Tape
: 250 mV / 47 kOhms
- TV
: 250 mV / 47 kOhms
- VCR
: 250 mV / 47 kOhms
- 6CH/DVD
: 250 mV / 47 kOhms
•
Audio output sensitivity
- CDR/Tape
: 250 mV / 1 kOhm
- VCR
: 250 mV / 1 kOhm
- headphone
: 3 V / 60 Ohm
- subwoofer pre-out
: 0.8 / 1 kOhm
- centre pre-out
: 0.8 / 1 kOhm
Tuner (typical values)
•
FM section
- wave range
: see table on back side
Sensitivity at 75 Ohm
- Mono 26 dB S/N
: 15 dBf
- Stereo 46 dB S/N
: 41 dBf
- Selectivity
: 55 dB at 300 kHz
- Distortion mono/stereo
: 0.85%,0.3%
- Frequency response
: 65Hz-12.5KHz,
±
1dB
- S/N ratio mono/stereo
: 65 / 55 dB
- Stereo separation (1KHz)
: 35 dB
- Image rejection
: 100 dB
- IF suppression
: 100 dB
Sub carrier suppression
- for 19 KHz
: 30 dB
- for 38 KHz
: 37 dB
•
AM section
- Wave ranges
: see table on back side
- Sensitivity MW
: 1.5 mV/m
- Selectivity
: 30 dB
- IF rejection
: 50dB
- S/N ratio
: 50dB
General
•
Power supply
- mains voltage
: see table on backside
- power consumption
: < 2W (in standby)
:
≈
210W (in 4 channel operation)
- electrical requirements
: IEC65
•
Remote control
- keys
: 42-keys
- codes
: RC5, RC6
- type
: Philips Audio & Video products
•
Set
- material / finish
: metal, hot-stamp foil on ABS
- dimensions (incl. feet)
: 435mm x 135mm x 350mm ( W x H x D )
- display
: 2 color starburst FTD
- weight
: 8.6 Kg
•
Speakers
- left, right
: 219mm x 421mm x 191mm (W x H x D)
- center
: 435mm x 131mm x 122mm (W x H x D)
- rear
: 181mm x 179mm x 92mm (W x H x D)
•
Package
- dimensions
: 606mm x 498mm x 519mm (W x H x D)
- weight (incl. set + speakers) : 20.1 kg
•
Accessories
-
remote
control
- 2 AA carbon/zinc batteries
- speaker cables
: 2 x 4 m left, right, 3 m center
2 x 12m rear
-
instruction
manual
- quick installation card
-
warrantee
information
- AM loop + FM wire antenna
- scart to audio adaptor (/22)
