22
Philips · NeoPix Ultra 2
TV+
9.
Warranty card
Model
NPX644/INT
EAN: 7640186961042
UPC: 793565993459
CE statement
•
The product shall only be connected to a
USB interface of version USB 2.0 or higher.
•
Adapter shall be installed near the
equipment and shall be easily accessible.
•
The operating temperature of the EUT can’t
exceed 35°C and shouldn’t be lower than
5°C.
•
The plug is considered as disconnect device
of adapter.
•
The UNII Band 5150-5250 MHz is for indoor
use only.
•
The device complies with RF specifications
when the device is used at 20 cm from your
body.
Hereby, Screeneo Innovation SA declares that
this product is in compliance with essential
requirements and other relevant provisions of
Directive 2014/53/EU.
The Declaration of Compliance can be
consulted on the site www.philips.com.
Frequency bands
Maximum output
power
BT EDR (EIRP)
9.09 dBm
BT BLE (EIRP)
4.85 dBm
Wi-Fi 2.4GHz (EIRP)
17.88 dBm
Wi-Fi 5GHZ (EIRP)
17.89 dBm
FCC statement
15�19 Labeling requirements�
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
15�21 Information to the user�
Any changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
15�105 Information to user�
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/
TV technician for help.
During operation, the separation distance
between the user and the antenna shall be
at least 20 cm. This separation distance will
ensure that there is sufficient distance from a
properly installed externally-mounted antenna
to satisfy the RF exposure requirements.
FCC ID: 2ASRT-NPX644/INT
Canada regulatory
compliance
This device complies with Industry Canada CAN
ICES-3 (B)/NMB-3(B)
RSS-Gen & RSS-247 statement:
This device
complies with Industry Canada RSS standard(s).
Operation is subject to the following two
