8
Philips · NeoPix Ultra 2
TV+
Prepare the remote control
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1
Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/- ) indicated.
3 Close the battery compartment.
•
When using the remote control with infrared
signals, point the remote control at the IR
sensor on the projector, and make sure
there is no obstacle between the remote
control and the IR sensor.
Power on and set up the
projector
1
Press to turn on the projector. The LED
on the projector turns from red to white.
•
To turn off the projector, press twice. The
projectors enters standby mode and its LED
turns from white to red. To fully shut down
the projector, disconnect the power cable
from the electrical socket.
•
The distance between the projector and the
projection surface determines the actual
screen size.
Screen size adjustment
The projection screen size (or size of images) is
determined by the distance between the lens
of the projector and the projection surface.
This projector has a projection distance of 80
cm to 200 cm, and thus creates a screen size of
20" to 120".
Screen height adjustment
You can adjust the screen height when placing
the projector on the table.
1
Find the height adjustment foot and the
foot release slider on the bottom of the
projector.
To unlock the height adjustment foot,
push the foot release slider in the direction
of the arrow shown below and hold the
slider. Then the foot will extend outwards
when the bottom of the projector points
downwards.
Adjust the length of the foot when the foot
is unlocked and extends outwards.
2 Lock the foot when the desire screen height
is reached. Simply release the slider to lock
the foot.
Height
adjustment
foot
Foot
release
slider
