1
100
80
60
40
20
2A. TO (RE)CHARGE
1. First time charging
requires a full 4 hours.
After the initial charge,
recharging requires only
1/2-hour. A fully charged
razor will give approxi-
mately 2 weeks of 3
minute shaves per day.
■
Use only the cord provided.
■
(Re)charge at tempera-
tures between 40°F and
95°F. Charging at lower
or higher temperatures
adversely affects life-
time of batteries.
2. Slide ON/OFF switch to OFF.
3. Connect cord to razor.
Plug into 100V to 240V
AC outlet.
4. When (re)charging, block
“20” may briefly light red.
After approximately 3
minutes, block “20” will
then turn green and blink.
Your razor is sufficiently
c h a r g e d f o r o n e 3 - 5
minute cordless shave.
■
As razor continues to
(re)charge, successive
blocks “40”, “60”, “80”
and “100” will briefly blink
green and then light.
■
(Re)charging longer
than required period of
time will not harm razor.
However, continuously
charging razor will re-
duce life of batteries.
4. CORD/CORDLESS
SHAVING
CORD
1. Connect cord provided
to razor.
2. Plug into 100V to 240V
AC outlet.
3. Slide and depress ON/
OFF switch ON. Begin
shaving.
4. Turn razor OFF and un-
plug.
IMPORTANT:
It is not
recommended that this
razor be used exclusively as
a corded razor. Continual
use as a corded razor as
well as continuously charg-
ing razor will reduce life of
batteries.
NOTE:
Razor does not re-
charge during corded shav-
ing.
CORDLESS
1. Charge according to
directions. Unplug razor
from outlet.
2. Slide and depress ON/
OFF switch ON. Begin
shaving.
5. SHAVING
1 . R e m o v e P r o t e c t i v e
Razor Head Assembly
Guard. Turn razor ON.
2. Shave against the direc-
tion of beard growth
using a quick, circular
motion.
3. Keep the skin taut using
your fingers to stretch
the skin so blades can
lift and cut whiskers off
(Fig. 2).
4. Easy does it. Gently
press the razor to your
skin so the floating
heads can follow the
contours of your face.
5. Turn razor OFF (and
unplug if shaving with
cord).
IMPORTANT:
Clean razor
head regularly following
MAINTENANCE
instruc-
tions.
1. Switch razor ON.
2. Push Trimmer Slide Switch
up to pop out Trimmer.
3. Hold Trimmer, as shown
(Fig. 3), to exact hairline
desired. Move Trimmer
downward with gentle
pressure.
4. Close Trimmer by push-
ing Trimmer Slide Switch
down.
5. Turn razor OFF (and unplug
if shaving with cord).
8. MAINTENANCE/
CLEANING
INSTRUCTIONS
IMPORTANT
■
Always switch razor
OFF and remove plug
f r o m o u t l e t b e f o r e
cleaning.
■
Always store razor with
Protective Plastic Head
Guard on Razor Head
Assembly.
■
Never clean, remove or
replace head assembly
while motor is on.
■
Do not apply pressure
to combs. Do not touch
razor heads with hard
objects as this may dent
or damage precision-
made slotted combs.
■
D o n o t u s e r a z o r i f
combs are damaged or
broken.
4
2
3
1. CHARGE METER
The Charge Indicator Meter
(Fig. 1) indicates the amount
of charge remaining in
rechargeable batteries. The
highest number displayed
on meter is the maximum
percentage of capacity
remaining (“40” means
40%) and will be visible for
approximately 8 seconds
when razor is turned on or
off and then will disappear.
IMPORTANT:
Before
using, the razor must be
charged for a full 4 hours if:
■
Your are using it for the
first time.
■
Razor has not been
used for at least a
month.
■
Entire meter is blank.
3. WHEN
TO
RECHARGE
■
The highest number
displayed on meter is
the maximum percent-
age of capacity remain-
ing (“40” means 40%).
■
Charging blocks do not
remain lit while shav-
ing. They are only visi-
ble for approximately 8
seconds when razor is
turned on or off, and
then will disappear.
■
When block “20” lights
red and briefly blinks this
indicates it is time to
recharge your razor.
3A. 1/2-HOUR QUICK
CHARGE
■
A f t e r i n i t i a l 4 h o u r
charge, your razor will
take only 1/2-hour to
(re)charge batteries to
full capacity.
3B. FAST SIX-MINUTE
QUICK CHARGE
■
W h e n b a t t e r i e s a r e
totally depleted, recharg-
ing for 6 minutes gives
enough energy for one
3-5 minute cordless
shave.
■
Recharge your razor
until the red block “20”
turns green. Your razor
i s t h e n s u f f i c i e n t l y
c h a r g e d f o r o n e 3 - 5
minute cordless shave.
Block “40”
indicates 40%
cell capacity
remaining
7. TO CLEAN TRIMMER
1. Switch razor OFF (and un-
plug if shaving with cord).
2. Push Trimmer Slide
Switch up to pop out
Trimmer.
3. Brush out Trimmer sec-
tion using long bristles
of brush.
4. Lubricate Trimmer teeth
twice a year with Norelco
Razor Lubricant, model
AL80, or one drop min-
eral oil.
5. Push T r i m m e r S l i d e
Switch down.
6. POP-OUT TRIMMER
