16
EN
8 Listen to radio
Tune to a radio station
1
Press
TUNER
on the remote control, or
(Left) on the main unit repeatedly to select
FM or AM.
2
Press and hold / .
»
[SEARCH] (search) is displayed.
»
The radio automatically tunes to a
station with a strong signal.
3
Repeat step 2 to tune to more stations.
•
To tune to a station with a poor signal,
press /
repeatedly until you find
optimal reception.
Program radio stations
manually
You can program a maximum of 30 FM and 10
AM preset radio stations.
1
Tune to a radio station.
2
Press
PROG
to activate program mode.
»
A position number is displayed.
3
Press
ALB//-
to allocate a
number to this radio station, then press
PROG
to confirm selection.
4
Repeat the above steps to program other
stations.
Tip
•
To overwrite a programmed station, store another
station in its place.
Program radio stations
automatically
In the tuner mode, press and hold
PROG
for
more than 2 seconds to activate automatic
program mode.
»
[AUTO] (auto) is displayed.
»
The unit automatically stores radio
stations with sufficient signal strength.
»
After all available radio stations are
stored, the first stored radio station is
broadcast automatically.
Select a preset radio station
In tuner mode, press
ALB//-
to select
a preset number.
Tip
•
Position the antenna as far as possible from TV, VCR or
other radiation source.
•
For optimal reception, fully extend and adjust the
position of the antenna.
Change AM tuning grid
In some countries, the AM radio frequency step
between adjacent channels is 10 kHz (9 kHz in
some areas).
1
Select the tuner source.
2
Press and hold for more than 5 seconds.
»
The frequency step is changed to 9
kHz or 10 kHz.
»
All preset stations are erased and re-
programmed in AM mode.
Summary of Contents for NTRX510
Page 2: ......
