Automatically setting the remote control
If you cannot find the right code for your brand device,
the remote control can automatically search for the right code.
Example of TV:
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU545 emits the ‘switch off TV’ signal for all models of TV that are
stored in the memory.
•
If the device is a DVD-player or video recorder,
insert a disk or tape and start playback.
2
Then keep keys 1 and 3 on the RU545
pressed simultaneously for five seconds
, until
the green light under TV in the selector
window flashes twice and then remains lit.
3
Press the Standby key of the RU545 briefly.
–
The RU545 now starts emitting all known
‘TV off ’ signals, one by one.
Each time a code is sent, the green light under
TV in the selector window lights up.
4
When your TV switches off (stand-by),
you press the Standby key of the RU545 twice
within 1 second, to confirm.
–
The RU545 has now found a code that works
on your TV.
5
Check if you can operate all functions on your
TV with the RU545.
•
If this is not the case, you can redo the automatic setting.
The RU545 will then search for a code that perhaps works
better.
–
After the RU545 has run through all the known codes,
the search will stop automatically and the green light will stop flashing.
–
Automatic programming of a TV takes a maximum of 3 minutes.
6
Instructions for use
English
M
EN
U
OK
SHIFT
1
2
3
4
5
6
7
8
0
9
TV
VCR
SAT DVD
TV
VCR
SAT DVD
TV
VCR SAT DVD
2 x
XP SBC RU 545/00U.2 08-04-2004 11:32 Pagina 6
