Warning
Never remove the casing of this player.
Never lubricate any part of this player.
Never place this player on other electrical equipment.
Keep this player away from direct sunlight, naked flames
or heat.
Never look into the laser beam inside the player.
Ensure that you always have easy access to the power
cord, plug or adaptor to disconnect the player from the
power.
•
•
•
•
•
•
How to connect a plug
The wires in the mains lead are coloured with the
following code: blue = neutral (N), brown = live
(L).
As these colours may not correspond with the
colour markings identifying the terminals in your
plug, proceed as follows:
Connect the blue wire to the terminal
marked N or coloured black.
Connect the brown wire to the terminal
marked L or coloured red.
Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
coloured green (or green and yellow).
•
•
•
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath
of the lead - not simply over the two wires.
Mains plug
This apparatus is fitted with an approved 13 Amp
plug. To change a fuse in this type of plug proceed
as follows:
a
Remove fuse cover and fuse.
b
Fix new fuse which should be a BS13625
Amp, A.S.T.A. or BSI approved type.
c
Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should have
a value of 5 Amp. If a plug without a fuse is used,
the fuse at the distribution board should not be
greater than 5 Amp.
The severed plug must be disposed off to avoid a
possible shock hazard should it be inserted into a
13 Amp socket elsewhere.
Norge
Typeskilt finnes på apparatens bakside.
