1.0 TECHNICAL SPECIFICATION
Factory Service Mode (FSM)
Procedure to change region code of your DVD
Portable
1. Power on the DVD player and do not insert
DISC inside player
2. Press the remote button in the sequence as
9 -> 6 -> 5 -> 3
The LCD display showed the existing region
code.
3. Press
(navigation up) or (navigation
down) repeatedly to select the number from 0
to 6.
4. Then press OK to confirm your region code.
5. Refer below table for your region code setting
Procedure for SW upgrade
1. Download the “PHILIPS.
AP
” file from the
Philips support site
2. Unzip the file, Drag-n-drop to
SD card
drive
3. Power on PET
744
with AC/DC adapter
4. Insert the
SD card
drive to
SD card
port of the main
set
5. The set will detect the upgraded SW
6. Press “OK” to confirm and proceed
7. The set will reset once finished upgrade
Warning: Do not unplug the AC adapter
during firmware upgrade to prevent flash
corrupt of the set!!
Procedure to check SW version of your DVD
Portable
1. Power ON the DVD player and no insert
DISC
2. Press the remote button in the sequence as
3->3->0->8,then a menu will be show XX-YY
YY-MM-DD
Summary of Contents for PET744
