P
Po
ow
we
err ssu
up
pp
pllyy
You can use the following batteries with this CD-player:
> PHILIPS rechargeable batteries, HF18/07/68
IIn
nsse
errttiin
ng
g rre
ec
ch
ha
arrg
ge
ea
ab
blle
e b
ba
atttte
erriie
ess
1
Press and lift to open the CD lid.
2
Open the battery compartment (inside the CD player).
3
Insert batteries with correct polarity.
Remove batteries if the player is not going to be used for a long time.
Batteries contain chemical substances, so they should be
disposed of properly.
C
Ch
ha
arrg
giin
ng
g
1
Insert the rechargeable battery.
2
Connect the power adapter to the 4.5V DC jack of the player and then to the wall outlet.
Recharging stops after battery is full or when you start playback.
3
When the battery is fully recharged, B
BA
AT
TT
T F
FU
UL
LL
L appears in the display.
The approximate power level of your batteries is shown on the display.
TIP
> It is normal for the batteries to become warm during recharging.
> If the batteries become too warm, recharging will be interrupted for
approximately 30 minutes.
> To ensure proper recharging on board, take care that contacts are clean.
> Recharging already charged or half-charged batteries will shorten their lifetime.
We therefore recommend that you let the rechargeable battery run till it is
completely empty before you recharge it.
> To avoid a short circuit, do not let the battery touch any metal object.
> If the battery becomes empty soon after recharging, then either its contacts
are dirty or it has reached the end of its lifetime.
✔
x 2
2
PSA410-ENG.QXD 11/6/04 9:52 Page 2
Summary of Contents for PSA410
Page 1: ......
