Philips Saeco Xsmall HD8745/57, Operating Instructions Manual

• 10 •

Coff ee Grinder Adjustment

W a r n i n g !   T h e   g r i n d e r 
adjustment knob, inside the 

coff ee bean hopper, must be turned 
only when the grinder is working. Do 
not pour ground and/or instant coff ee 
into the coff ee bean hopper.  

Do not insert any material 
other than coff ee beans into 

the hopper. The grinder contains 
moving parts that may be dangerous. 
Therefore, do not insert fi ngers and/
or other objects. Only adjust the 
grinder using the grinder adjustment 
key. Turn off  the machine by pressing 
the ON/OFF button and remove the 
plug from the socket before carrying 
out any type of operation inside the 
coffee bean hopper. Do not pour 
coff ee beans when the coff ee grinder 
is working.

The machine lets you make slight 
adjustments to the coffee grinder to 
adapt it to the kind of coff ee used.

This adjustment should be carried out 
by adjusting the pin on the inside of the 
coffee bean hopper; this pin must be 
pressed and turned only with the grinder 
adjustment key provided with the coff ee 
machine. 

Press and turn the pin one notch at a  
time. You must brew 2-3 coffees before 
you will taste a diff erence.

The reference marks inside the coffee 
bean hopper indicate the grind setting. 
There are 5 diff erent grind settings to cho-
ose from with the following references:

1 - Coarse Grind
2 - Fine Grind

Adjusting the Brewed Coff ee

The machine allows you to adjust the 
amount of brewed coffee according to 
your taste and/or the size of your cups.

Each time the “

 “ or “

 “ buttons 

are pressed and released, the machine 
brews a pre-set amount of coffee. This 
amount may be reprogrammed to your 
taste. Each button may be individually 
programmed for a specifi c brew setting.

As an example, the following procedure 
describes the programming of the small 
coffee button “

 “, which is normally 

associated with espresso coff ee.
•  Place a cup under the dispensing 

spout.

•  Press and hold down the “

 “ button; 

the “

“ light blinks during this 

phase.

• Release 

the 

“

 “ button when the 

amount of coffee in the cup reaches 
the desired level.

At this point the button “

 “ is pro-

grammed; each time it is pressed and 
released, the machine will brew the same 
amount of coff ee that was just program-
med.

1

1

2

2

Blinking

Standby

The machine is designed for energy sa-
ving.
After 60 minutes of inactivity, the machi-
nes turns off  automatically.

Note: During the turning off  
phase, the machine performs 

a rinse cycle, if a coff ee product has 
been brewed.

To turn the machine on again, simply 
press the ON/OFF button; in this case the 
machine will go through the rinse cycle 
only if the boiler is cold.