Philips Saeco Xsmall HD8745/57, Operating Instructions Manual

• 8 •

•  Make sure control dial is on  “ ” posi-

tion; if this is not the case, set it to that 
position.

•  Simply press the ON/OFF button to 

turn the machine on; the  “ “ light will 
begin to blink rapidly indicating that 
the water circuit must be primed.

Note: Before starting the 
machine for the first time, 

prime the water circuit.

Using the machine for the 
first time or after a long 
period of inactivity.

These simple operations will make it pos-
sible to always brew excellent coff ee.
They have to be performed:
A)  At fi rst start-up.
B)  When the machine remains inactive 

for a long time (more than 2 weeks).

Dispensed water must be em-
ptied into an adequate drain. 

It is not suitable for food use.

1  Place a container under the dispensing 

spout. 

2  Before starting the procedure, check 

that the “ “ light is steady on.

Priming the Water Circuit

•  To prime the water circuit, place a 

container under the hot water / steam 
wand.

•  Turn the control dial clockwise to set it 

to the  “

” position and wait. 

  When water steadily comes out and the  

“ “ light will blink slowly - indicating 
that the knob can be turned off  - rotate 
the control dial counter-clockwise to set 
it back to the  “ ” position.

•  At this point the  “ “ light begins to 

blink slowly, indicating that the ma-
chine is in warm-up mode.

When warm-up is complete, 
the machine performs a rinse 

cycle of the internal circuits.

•  When the above steps are complete, 

check that the  “ “ light is on steady.  
The machine is now ready for use. 

•  To brew coff ee, dispense hot water or 

steam, and for a proper use of the ma-
chine, carefully follow the instructions 
provided.

3  Brew one coff ee. Press and release the 

“

“ button. The machine starts 

brewing coff ee.

4  Wait until brewing is complete and 

remove the container.

5  Place a container under the steam wand 

(Pannarello, if supplied).

6  Turn the selector switch clockwise to 

the “

” position.

7  Dispense water until the no water 

signal is displayed. The “

” light re-

mains steady on. 

  Now turn the selector switch counter-

clockwise to set it back to the “ ” po-
sition.

8  At the end, fill the water tank again. 

Then the products can be brewed as 
described in the following sections