ENGLISH
Epilating head:
With the epilating head you can remove body hair by
the roots. The optimal hair length for epilation is 3 to 4mm.
Skin stretcher
: The skin stretcher keeps the skin tight during epilation
to reduce pain.
Sensitive cap
: The sensitive cap covers part of the epilator discs and
is used to epilate sensitive areas.
Active hair-lift and massage cap:
Lifts flat lying hairs so that they can
be removed easily. The massaging roller vibrates to give a pleasant sensation
on the skin that soothes the effect of epilation.
Massage rollers:
The massage rollers help to stretch the skin and give
a pleasant sensation on the skin that soothes the effect of epilation.
Shaving head
: The shaving head is intended for shaving the more sensitive
areas such as bikini line and underarms. The hairs are shaved at the surface
of the skin instead of removed by the roots.
Protection cap
: The protection cap protects the shaving head during
travel and storage.
Trimming comb
: The trimming comb can be attached onto the shaving
head to trim hair to a length of 3 to 4mm. You can use it for the bikini area.
If you want to epilate, the trimming comb provides the optimal hair length
for epilation.
Pouch:
To store the appliance, attachments and adapter.
Brush:
To clean the appliance and attachments.
Exfoliation glove:
The exfoliation glove removes dead skin cells and
helps to prevent ingrowing hairs. Use it 24 hours before epilation or
48 hours after epilation.
Charging
Insert the small plug into the socket in the bottom of the appliance and put
the adapter in the wall socket.
Charging the epilator takes approximately 1 hour. When the epilator is fully
charged, it has a cordless operating time of up to 30 minutes.
Charging light
The charging light:
- Flashes white to indicate that the appliance is charging.
- Lights up white continuously to indicate that the battery is fully charged.
It goes out after 20 minutes.
- Flashes red to indicate that the battery is almost empty.
- Lights up red continuously to indicate that the battery is completely empty.
Using the appliance
You can use the on/off button to select two different speeds.
- Press once for speed II: the most efficient speed for epilating.
- Press twice for speed I: is suitable for areas with little hair growth,
for hard-to-reach areas and for areas where bones are located
directly beneath the skin, such as knees and ankles.
Epilating
For the best results, place the epilating head at an angle of 90° onto the skin
with the on/off button pointing in the direction in which you are going to
move the appliance. If you are not using the skin stretcher, stretch the skin
with your free hand to make the hairs stand upright.
Cleaning
Remove the attachment from the epilating head and remove the epilating
head from the appliance. Use the cleaning brush to remove loose hairs.
Rinse all attachments under the tap and shake off excess water.
Detaching and attaching
To detach the epilating or shaving head, push it in the direction of the
arrows on the back of the appliance and pull it upwards.
To attach the epilating or shaving head, put it on the appliance and push
it against the direction of the arrows on the back of the appliance.
