RU230- page 6
6
SBC RU 230
Instructions for use
READING OUT THE 3-DIGIT BRAND CODE
After using autosearch to set up the SBC RU 230, note the 3-digit code for
future use.
1.
Press the button of the device [TV, VCR or AUX] you want to read the code
from.
2.
Press and hold
1
and
6
at the same time for 3 seconds.
– The indicator LED lights up.
3.
Press -/--;
– The LED indicator goes out.
4.
Press 1:
– the indicator starts to blink; Count the number of blinks for the first digit.
Note: if the indicator does not blink, the digit is 0.
5.
Press 2:
– the indicator starts to blink; Count the number of blinks for the second
digit.
6.
Press 3:
– the indicator starts to blink; Count the number of blinks for the third digit.
7.
Write down the code inside the SBC RU 230's battery lid.
USING THE AUX BUTTON
The AUX button can be used to control a second TV or VCR receiver. The AUX
button is pre-installed for a second video recorder. If you want to operate a
second TV instead, proceed as follows:
1.
Press and hold
1
and
6
at the same time for 3 seconds.
– The indicator LED lights up.
2.
Enter 9,9,2
3.
Press TV,
4.
Press AUX
– Now follow the procedures in the Chapter
SETTING UP BY CODE ENTRY
to
enter the code for your second TV.
FREE-PHONE HELP-LINE
If you have any problems with your Philips Universal remote control, please ring
our free-phone help-line.
United Kingdom: 0800-968-118
Ireland: 1-800-533-136
Before calling, note the data of your equipment in the table below.
This makes it easier and faster for us to help you.
Type-numbers can usually be found in the original manual, or on the factory
plate on the back of the equipment.
English
Device
TV
VCR
AUX
Brand
Model nr.
RC model nr.
Used code
Summary of Contents for SBC RU 230
Page 40: ...RU240 page 40 40 ...
Page 41: ...RU240 page 41 ...
Page 42: ...RU240 page 42 TCtext CvB 9723 Philips SBC RU 240 ...
