TROUBLESHOOTING GUIDE
• Problem:
– Solution:
• Device is not responding and the green light does not flash
when you press a button.
– Replace batteries with two new 1.5 volt, type RO3, UM4 or
AAA batteries.
• Device is not responding, but the green light does flash when
you press a button.
– Aim the SBC RU530 at the device and be sure that there are
no obstructions between the SBC RU530 and the device.
• The SBC RU530 is not performing commands properly.
– You may be using the wrong code. Try repeating Set up using
another code, listed under your brand, or start the Autosearch
Set-up over again to locate the proper code.
If the device still doesn’t respond, call the help-line and we’ll
put you back on track.
• You can’t access teletext pages and you were used to use this
(
fi
) button to access teletext.
– Follow Set up procedure and at step 5 of section “Your
equipment is of another brand, or your equipment is a Philips
brand, but not all keys respond correctly” press keys
0, 0, 6 and 4.
To enter teletext pages, press the teletext cancel button.
• The teletext buttons do not work.
– Be sure your TV has teletext capabilities. The SBC RU530 does
not extend the capabilities of your TV!
• Having problems operating all the functions on your device.
– The SBC RU530 may just need customising for your model
type. Just call our help-line and we’ll put you back on track.
• Your brand is not listed in the code list.
– Try the hands-free Autosearch method.
• You want to reset the remote control to its factory preset.
– 1 Press and hold keys
1 and 6
simultaneously - for about
3 seconds - until the green LED lights up.
– 2 On the keypad, press keys 9, 8, and 1.
The LED flashes twice to indicate a successful reset.
Instructions for use
8
English
0
0
6
4
1
6
9
8
1
XP SBC RU 530/00 31-05-2001 16:02 Pagina 8
Summary of Contents for SBCRU530
Page 70: ...Notes ...
Page 71: ...Notes ...
