6
EN
3 Get started
Caution
•
Use of controls, adjustments, or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Connect power
Caution
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the speaker.
Connect the AC power adaptor(not supplied)
to:
•
the power supply socket on the back of
the speaker.
•
the wall power outlet.
DC IN
5V . 1A
Built-in Battery
The speaker can also operate on built-in
rechargeable battery.
To recharge the built-in battery:
•
Connect the speaker to the power supply.
Note
•
Use only the supplied USB cable to charge the battery.
Turn on
Switch
ON/OFF
on the speaker to the ON position.
»
The Bluetooth indicator flashes (blue).
Switch to standby mode
The speaker switches to standby mode in the
following situations.
•
In Bluetooth mode
: no audio signal from
your Bluetooth device over 15 minutes.
•
In MP3 link mode
: no audio signal
detected over 15 minutes.
•
The battery level is low.
Note
•
The Bluetooth connection will be terminated when the
speaker enters standby mode, you can wake up the
speaker by hold
for 2 seconds.
