5
PL1IRR Remote Control
User’s Guide
OPERATION AND PROGRAMMING
Using the PL1IRR Infrared Remote Control
To select and program PL1 LED luminaire with PL1IRR remote:
Note:
The IR, on the PL1 LED luminaire, must be set to "Enabled" in order for the PL1IRR remote to communicate
and control the fixture. Refer to PL1 LED Luminaire Installation & User’s Manual on luminaire menu settings.
Step 1. Point PL1IRR programming remote
Laser / IR window directly at luminaire
IR programming window (as shown in
Figure 2
) and hit "Enter" button. Note,
each luminaire to be programmed/
adjusted needs to be selected and
programmed/adjusted individually.
Step 2. Point PL1IRR remote directly at
luminaire IR window and hit "Laser"
button. Luminaire to be programmed or
adjusted is now selected.
Note:
At luminaire IR port, a Blue LED will
illuminate when the fixture is in programming
mode and blink Red when buttons are pressed on
IR remote to confirm it sees the remote and is
receiving commands.
Step 3. Set luminaire to preset or make
adjustments as desired.
Step 4. To save settings, hit "Learn" button and
then hit any Preset button (except Off -
Off cannot be programmed). Preset is
now saved. To cancel programming, hit "Cancel" button.
Step 5. After programming or adjustments are complete, hit "Exit" button. Repeat, as desired, on additional
luminaires to be programmed/adjusted.
Note:
Refer to PL1 LED Luminaire Installation & User’s Manual for additional information. This manual is
available on the Philips Selecon web site at www.seleconlight.com.
Troubleshooting
Description
Symptom
Possible Cause/Remedy
IR remote programming.
Fixture will not respond to IR
remote programming unit.
Luminaire not selected by laser...
Reselect luminaire by repeating luminaire selection step.
Not seeing IR remote control...
Make sure batteries are good in remote. Try fresh, fully charged
batteries.
Make sure IR is enabled in the fixture menu.
Insure IR remote is pointing at IR window in luminaire and that there
is nothing in between IR remote and luminaire IR window.
Clean luminaire IR window.
LEARN
EXIT
1
LASER
COLOR
PRESETS
ENTER
PROGRAM
CANCEL
RED
GREEN
BLUE
WHITE
S
S
S
S
T
T
T
T
WHITE
2
3
4
5
6
OFF
WARM
COOL
DAY
INTENSITY
PL1IRR
PL1 LED Luminaire
(IR-enabled model)
PL1IRR Remote Control
PL1 IR
Port
Figure 3: PL1 LED Luminaire Programming / Control
