7
English
EN
Operate the headset
Enter pairing mode
Ensure the headset is off. Press
until
LED starts blinking red/blue alternately.
Check battery
When first use: Hold for 2 seconds.
During operation: Hold
VOL +
and
VOL
-
simultaneously.
>50%: 1 blue flash
>25%: 2 red flash
<25%: 3 red flash
Turn headset on/off
Hold
until LED turns on/off.
Play/Pause music
Tap
Stop music
Hold
Next / Previous track
Tap /
Adjust volume
Press
VOL +
/
VOL -
Pick up / End a call
Tap
Reject a call
Hold
Redial the last number
Press
twice quickly.
Activate voice dialing*
Hold
until beep occurs.
Mute/Unmute the Mic
Double tap
during a call.
Transfer a call to a
mobile phone
Hold
during a call.
* Available if supported by your mobile phone.
Manage 3-way calls
If your mobile phone and network operator support 3-way-calls, you
can manage 3-way-calls via the headset.
To hold the active call and
accept a waiting call
Press while the 2nd call is
coming in.
To drop the active call and
accept a waiting call
Hold while the 2nd call is
coming in.
To swap a call
Press
during a call.
LED and sound indication
The red/blue LED flashes alternately.
The headset is ready for
pairing.
The blue LED flashes once every 6
seconds.
The headset is connected
to the device.
The blue LED flashes twice every 3
seconds.
The headset is not
connected.
The blue LED flashes once every half
a second.
There is an incoming/
outgoing call.
The blue LED flashes once every
second.
The headset is active on
a call.
The red LED flashes three times and
beeps twice every minute.
The battery is low in
power.
Solid red LED.
The headset is charging.
The LED is off.
The headset is off./Charging
is finished.
The headset beeps every 5 seconds. The Mic is muted.
Clean the headset
A few ways to clean the headset:
Wipe with clean cloth.
•
Wash it under running tape water.
•
Caution
Do not dive with this product or immerse it into water.
•
4 Use the headset
Connect the headset to your mobile phone
1
With the mobile phone turned on, press until the LED lights
up, to turn on the headset.
Once turned on, the headset reconnects automatically to
»
the last device it was connected to.
If the last connected device is not available, the headset
»
tries to reconnect to the second to last device that was
connected to the headset. If it cannot find this device, it
will look for all previously paired devices in the order of
last usage, until it finds a device to connect to. The headset
stores up to three previously paired devices.
Tip
If you turn on the mobile phone or its Bluetooth feature
•
after
turning
on the headset, connect the headset from the Bluetooth menu of
your mobile phone.
Automatic power saving
If the headset cannot find any Bluetooth device to connect to in
range within five minutes, it automatically powers down to save
battery life.
Get the best fit
1
Choose the earbuds that best fit for your ear canal.
2
Gently blend the ear hook to fit into your ears.
3
Adjust the rubber part of the ear hook to the height that you
feel fit.
4
Twist the earbuds to the right position for best fit and noise
isolation.
