EN 48
12.
MCP9360i
Hardware Repair
12.9. SW Board & RF Receiver
12.9.1. SW Board & RF Receiver Removal
1.
Remove the top cover. See paragraph 12.1.1.
2.
Remove the main bezel. See paragraph 12.2.1.
3.
Disconnect all cables (1) from the SW board & RF receiver. See Figure 12.9-1.
4.
Remove the 4 mounting screws (2) from the SW board & RF receiver. See Figure 12.9-1.
5.
Remove the SW board & RF receiver from the chassis.
Note:
The RF receiver may be removed from the SW board by carefully pulling it out of its connector.
Figure 12.9-1
2
1
2
1
2
2
12.9.2. SW Board & RF Receiver Board Re-Assembly
To re-assemble the SW board & RF receiver, do all steps described in paragraph 12.9.1 in reverse order.
Note:
The torque setting required for the SW board & RF receiver mounting screws (2) is 6 kg-cm.
