Mechanical Instructions
4.
4.2.2
Power Switch removal
Figure 4-3 Power switch removal
1.
From the mono carrier disconnect the main power, the
degaussing coil, the speakers, the front control panel, the
side I/O panel and deflection coil cables. Release the main
power cord and the side I/O panel cable from it’s strain
reliefs. Pull out the mono carrier and place it sidewards.
This enables the removal of the power switch panel.
2.
Then, remove the two fixation screws (1) of the power
switch panel and remove the board.
4.2.3
Front Control Panel removal
Figure 4-4 Front Control Panel removal
1.
From the mainboard disconnect the main power, the
degaussing coil, the speakers, the front control panel, the
side I/O panel and deflection coil cables. Release the main
power cord and the side I/O panel cable from it’s strain
reliefs. Pull out the mono carrier and place it sidewards.
This enables the removal of the front control panel.
2.
Then, remove the four fixation screws (1) of the Front
Control panel and remove the board.
4.3
Set Re-assembly
To re-assemble the whole set, do all processes in reverse
order.
Be sure that, before the rear cover is mounted:
•
The mains cord is positioned correctly in its guiding
brackets (make sure that the strain reliefs are replaced in
its correct position and that it will function correctly!).
•
All wires/cables are returned in their original positions.
H_17210_026.eps
080607
1
H_17210_027.eps
080607
1
1
1
1
http://jdwxzlw.5d6d.com/?fromuser=森林
家电维修资料网
免费下载各种维修资料
