Mechanical Instructions
EN 7
SK5.1L CA
4.
4.2.2
Side I/O Panel removal
Figure 4-3 Side-I/O panel removal
1.
Disconnect the side panel cable from the mono carrier and
remove the cable from it’s strain reliefs.
2.
Then, remove the two fixation screws [1] and remove the
board.
When defective replace the whole unit.
4.3
Set Re-assembly
To re-assemble the whole set, do all processes in reverse
order.
Be sure that, before the rear cover is mounted:
•
The mains cord is positioned correctly in its guiding
brackets (make sure that the strain reliefs are replaced in
its correct position and that it will function correctly!).
•
All wires/cables are returned in their original positions.
I_17
88
0_00
3
.ep
s
270
3
0
8
1
