When battery is installed:
To switch on the Presenter, push the USB receiver into the
•
Presenter and then remove the USB receiver from it.
To switch off the Presenter, push the USB receiver to the end.
•
4 Auto-connect
1
Ensure that your notebook is switched on and active.
2
Ensure that your Presenter is switched on.
If the USB receiver is inserted into your Presenter, release the
•
USB receiver from your Presenter (Fig. 3).
3
Plug the USB receiver into a USB host on your notebook.
Auto-connection starts.
»
If connection is successful, the LED indicator indicates 1 long
»
blink.
If connection fails, the LED indicator indicates 2 long blinks.
»
The LED blinks upon ever y successful communication
»
between the Presenter and the USB receiver.
E
Tip
After use, insert the USB receiver into your Presenter for
•
storage (Fig. 4).
Upon the first installation on Mac,
•
Keyboard Set Assistant
may appear and prompt that the keyboard cannot be
identified. Just click
Continue
to finish the installation, and
then the Presenter will work accordingly.
5 Troubleshooting
No transmission.
Ensure that you use the Presenter
within effective range.
Light on your Presenter
blinks 3 times.
Replace battery on the Presenter.
Summary of Contents for SNP3000/10
Page 2: ...a b c d e f g h 1 ...
Page 3: ...2 3 4 ...
