23
5b.
Set application mode
Lock the group,refer to
step
4e
.
• After locking lighting
group is operational in
selected mode.
mode
Luminaire
Luminaire
The luminaire will
FLASH twice and
group light level will
go to 50%.
O)))
Point to
any
of
the luminaires
in the group and
press “mode.”
While the LED is still
blinking red, enter the
number for the preferred
mode (see list at step
5
).
Point to
any
of
the luminaires
in the group,
press “send.”
6.
Creating zones in a group
Red LED on
remote will
start blinking.
II
If unsure about mode selection or remote blinking status then wait
for the remote blinking to stop and redo step
5b
.
Luminaire
Up to 16 zones can be created within a SpaceWise group and each luminaire
can be part of just one zone.
All luminaires within the zone will react the same way to any sensor in the
zone. That is, all luminaires in the zone will simultaneously increase light
level upon motion detection or will simultaneously dim down to background
level when there is no motion.
1
2
3
5
4
Group
Zone
Zones can only be created within a group. A group needs be created
fi
rst as per the instructions in section
4
.
Summary of Contents for SpaceWise
Page 17: ...17 Industrial applications ...
Page 29: ...29 Troubleshooting FAQ ...