Philips SRP1103, User Manual

4

EN

English

5

EN

Getting star

ted

5

Switch ON

 the TV.   

Try out the buttons 

you need for 

operating it. Try, for 

example, if the  

- CH + and digit 

buttons function properly.

•   If a button does not work as expected, 

press 

and hold

 that button. Release it 

immediately 

as soon as it works. For more information, 

see chapter 

2.2.2

.

6

   Press the 

device selection 

button 

twice

 to 

finish setup.

  •

When no 

button is 

pressed for 5 minutes or more, the 

remote control will exit setup mode, 

automatically saving all your settings. 

Important

If you made a mistake:

•   Press the device selection button 

twice

 to 

exit setup.  

The red Setup light   turns off.

•  Restart from the beginning.

• 

 If the device does not respond at all or not to 

all of the button commands or if you cannot 

find the code for your brand, enter ‘9, 9, 9, 9’ in 

step 3 and continue with step 4. The remote 

control will now search its full database for a 

code that works with your TV. Full database 

search may take up to 15 minutes.

2.2.1   Setting up the remote control for 

other devices 

(DVD player / recorder 

and Cable / Satellite box)

1   

Make sure the device is switched on and 

operational. E.g. insert a disc in the DVD 

player / recorder.

2

   Then follow steps 

2

 to 

6

 of  ‘Setting up the 

universal remote control to operate your 

TV’. Make sure to use the correct device 

selection button: 

 or 

. 

CBL/SAT 

 Cable box, satellite 

receiver, Internet Protocol 

TV (IPTV), Free To Air TV, 

High Definition Television 

decoder (HDTV) and TiVo

Example:  setting up the universal remote 

control to operate your TV:

1

 Switch ON

 the TV manually or use the 

original remote control for this.  Tune to 

channel 1.

2

Press and hold

the  

 deviceselection 

button 

for 5 seconds

until the red Setup 

light   blinks. 

  •   The remote 

control is now in setup mode.

3

   Look up the 4-digit 

code for your brand 

in the brand list at 

the back of this user 

manual. 

   A 4-digit code is 

shown for each brand. 

   Use the digit 

buttons to enter the 

code for your brand.

  •   If the red Setup 

light   turns off,

an invalid code  

was entered. In this case, try again.

4

   Aim the remote 

control at the TV. 

Press and hold

 the 

 button. 

Release it 

immediately

 as soon 

as the TV switches off. 

  •

This step normally takes between 5 and 
60 seconds. In extreme circumstances 
this step can take up to 15 minutes.

5 sec.

5 - 60 sec.

5-60 SEC.

2 x