4
EN
5
EN
English
Getting
star
ted
To fully benefit from the support that Philips
offers, register your product at
www.philips.com/welcome.
2
Getting started
2.1 Inserting the batteries
•
Insert 2 AAA type
batteries, noting
the + and -
configuration in the
battery
compartment.
Note
When replacing the batteries, all user settings
will be retained in the remote control
memory for 5 minutes.
2.2 Setting up the universal remote
control
The example below instructs you how to set
up your universal remote control for your TV.
You can repeat the same steps for other devices
(DVD player / recorder, DTV, Cable / Satellite
box, DVR and VCR) which you want to operate,
using the universal remote control.
The remote control can be set up to operate
any 6 of the following devices:
Device name
Description
TV
Traditional TV, LCD /
Plasma TV and projection
TV, TV part of TV / VCR,
TV / VCR / DVD and TV /
DVD combos
DVD
DVD player / recorder
(DVDR), DVD / Hard
Disk Drive combination
(DVDR-HDD), Blu-Ray
player, High Definition
DVD player (HD-DVD),
DVD part of TV / DVD,
TV / VCR / DVD and VCR
/ DVD combos
CBL/SAT
Cable box, satellite
receiver, Internet Protocol
TV (IPTV), Free To Air TV,
High Definition Television
decoder (HDTV), Digital
Television (DTV) and Tivo
VCR
Video cassette player /
recorder, VCR part of TV/
VCR, TV/VCR/DVD and
VCR/DVD combos
DVR
Digital / Personal Video
Recorder (DVR / PVR)
and Tivo
Example: setting up the universal remote
control to operate your TV:
1
Switch ON
the TV manually or use the
original remote control for this. Tune to
channel 1.
2
Press and hold
the
device selection
button
for 5 seconds
until the red Setup
light blinks.
• The remote
control is now in setup mode.
3
Look up the 4-digit
code for your brand
in the brand list at
the back of this user
manual.
A 4-digit code is
shown for each brand.
Use the digit
buttons to enter the
code for your brand.
• If the red Setup
light turns off,
an invalid code
was entered. In this case, try again.
5 sec.