2.2
Testing the remote control
The SRP5002 is programmed to operate the most of the functions used
on Philips TV and DVD. Because the available functions are not the same
for all the Philips TV and DVD models, it is advisable to test whether
your device fully responds to the SRP
5002
.
Example of TV:
Turn your TV on manually or use the original remote control.
Tune to channel
1
.
Press the TV key to select TV.
• The key lights up.
• If the key does not light up, check whether the batteries are
properly inserted (see ‘
2.1
Inserting the batteries
’
).
Check whether all the keys are working.
For an overview of the keys and their functions see
‘3. Keys and functions’.
• If the TV responds as it should to all of the key commands the SRP5002
is ready for use.
Tip
If the TV does not respond at all or not to all of the key commands, follow
the instructions under ‘2.3 Setting the remote control’, or for online setup go
to: www.philips.com/urc.
2.3
Setting the remote control
This is only necessary if your device does not fully respond to all the
command keys of your remote control. If that is the case, the example
below instructs you how to look for a most suitable set up on the
remote control for your Philips branded TV or DVD.
Example of TV:
Press the mode key of the device you wish to set up the remote for.
E.g. the TV key.
1
3
3
2
3
1
2
2
EN
GL
ISH
4
Installing the remote control
EN
GL
ISH
SRP5002_MA190508_v6.qxd:125254c4_SRU5110_86 19/05/08 18:33 Página4
Downloaded from www.vandenborre.be
