Manually setting the remote control
1
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2
Look up the brand of your TV in the
code list at the back of this manual. One or
more four-figure codes are shown for each
brand. Note the first code.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
3
Keep keys 1 and 3
pressed simultaneously
for three seconds
until the LED
flashes twice and then remains lit
4
Then enter the code noted in step 2 using the
digit keys.
–
The LED will now flash twice and then remains lit.
The code has now been stored in the memory of the SRU 5010.
If the LED flashes once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
5
Point the SRU 5010 at the TV and check that it responds as it should.
–
If the TV responds to all of the key commands, the SRU 5010 is ready
for use. Do not forget to note your code.
•
If the TV does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
6
Instructions for use
English
Summary of Contents for SRU 5010/86
Page 2: ......
