Automatically setting the remote control
The remote control will now automatically search for the right code for your
device.
Example of TV:
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The SRU740 emits the ‘switch off TV’ signal for all models of TV that are
stored in the memory.
•
If the device is a DVD player/recorder or video recorder, insert a disk or
tape and start playback.
2
Press the SELECT key to select TV.
Press the key until the TV LED lights up.
3
Then keep keys 1 and 3
pressed
simultaneously for three seconds
until the TV
LED flashes twice and then remains lit.
4
Press and hold the Standby key of the
SRU740.
–
The SRU740 now starts emitting all known
‘TV off ’ signals, one by one.
Each time a code is sent, the TV LED
lights up.
5
When your TV switches off (stand-by), release
the Standby key of the SRU740 immediately.
–
The SRU740 has now found a code that
works on your TV.
6
Check if you can operate all functions on your TV with the SRU740.
•
If this is not the case, you can redo the automatic setting.
The SRU740 will then search for a code that works better.
–
After the SRU740 has run through all the known codes, the search will
stop automatically and the TV LED will stop flashing.
–
Automatic programming of a TV takes a maximum of 5 minutes.
For SAT, DVD/ VCR and AMP this time is 2 minutes.
6
Instructions for use
English
SRU740_10_v2.qxd 26-04-2005 15:19 Pagina 6
