Philips SRU4050 Owner'S Manual Download

Page: 6 / 26

Code Identification Feature

The Code Identification Feature allows you to identify
the 4 digit library code stored under your device key. For
example, if you want to find out what 4 digit code is
stored under your TV device key, follow the six steps
below:
1. Press and hold the

SETUP

button until the red

indicator stays on. Release the

SETUP

button.

2. Press and release the desired mode button (

VCR

, etc.). The red indicator blinks, then stays lit.

3. Press and release the

SETUP

button. The red

indicator blinks off.

4. To find the first digit for the code stored under the

mode key pressed in step 2, press each numeric key
from

0-9

in turn. When the red indicator blinks off

the number you pressed is the first digit for the code
you are searching for.

5. To find the second digit, repeat step 4, this time

when the red indicator blinks off this is the second
digit.

6. Repeat step 4 to find the third and fourth digits.

Sleep Timer

The

SLEEP

button operates the Sleep function of your

device providing it supports the Sleep function.
Alternatively, you can enable the remote to turn off
your TV after a period of 1 to 99 minutes as shown
below. This feature is only available for the TV Mode
and the remote must be in TV Mode to set a Sleep
Timer. This feature works even if your TV does not
have its own Sleep function.

1. Press and release the TV Mode button.
2. Press and hold the

SETUP

button until the red

indicator stays on. Release the

SETUP

button.

3. Press and release the

SLEEP

button (Note any

previously set Sleep timer is cancelled at this point
and the remote returns to normal operation).

4. Press and release the numeric buttons (

01-99

) for

the time required. The red indicator blinks off to
indicate button press acceptance and remains off
after the second button press.

5. TV Sleep Timer now set.

6. Leave the Remote pointing towards the TV with an

unobstructed path.

To cancel the Sleep Timer, press and release the

POWER

button in TV Mode or repeat Steps 1, 2 and 3

above.

Cable codes under

CABLE

, etc. If (for example) you

want to store a VCR code under

CABLE

, first follow the

procedure for Direct Code Entry (previous page) and
press

CABLE

in step 2 of Direct Code Entry, then enter

ANY VCR code in step 3 of Direct Code Entry. Then
follow the steps above for Code Search (or Brand
Search, below).

Note

: If the device does not have a

CHANNEL UP

button, use

PLAY

(VCR only) or

POWER

instead. Code Search starts from the currently

stored 4 digit number under that mode.

Code Search, cont.

Code Search by Brand

Lets you search for a code for a specific Brand within
the Code Library for a particular manufacturer.

1. Turn on the device (TV, VCR, etc.) to be controlled.
2. Press and hold the

SETUP

button until the red

indicator remains on, then release

SETUP

button.

3. Press and quickly release the desired mode button

(

VCR

, etc.). The red indicator blinks off once.

4. Press and release the numeric button (

0-9

)

corresponding to desired Manufacturer (see table on
code list sheet). The red indicator blinks off once.
Note, pressing “0” performs a full library search same
as normal Code Search Method on previous page.

5. Press the

CHANNEL UP

button ((or

POWER

PLAY

(VCR only)) repeatedly until the device to be

controlled changes channel. The red indicator blinks
off with each button press. If you accidentally
overshoot the code required, press the

CHANNEL

DOWN

button to backtrack through the library until

the device changes channel. Pressing

CHANNEL