ENGLISH
7
Important information
•
Please install and connect the product in the order as described in this manual only.
This assures best installation results with the least technical hassles.
•
Please read this guide carefully before using the SL400i; and keep it for future reference.
•
The most recent downloads and information on this product will be available through our
website www.philips.com/streamium.
•
Broadband Internet access (min. 256 kbps) is required if you want to use the Internet
functions of the SL400i.
•
Please check whether your Internet service provider charges extra fees for exceeding a
certain limit of transferred data.
When using Internet media services on a daily basis, you may exceed such a limit.
For example: When you listen to Internet radio (at 64 kbps) for about 36 hours,
1 GB (gigabyte) of data will be transferred to your streamium system.
Watching Internet video at 700 kbps exceeds a 1 GB limit in 3 hours.
•
During set-up and installation, it may be helpful to have the instructions for your TV set,
audio system and wireless base station or other wireless network components
(if appropriate) at hand.
Safety Precautions
•
NEVER MAKE OR CHANGE CONNECTIONS WITH THE POWER SWITCHED ON.
•
Before operating the system, check that the operating voltage indicated on the nameplate
(or the voltage indication beside the voltage selector) of your system is identical with the
voltage of your local power supply. If not, please consult your dealer.
•
Radio equipment for wireless applications is not protected against disturbance from other
radio services.
•
The product should not be exposed to dripping or splashing.
No object filled with liquids, such as vases, should be placed on the product.
•
Do not expose the system to excessive moisture, rain, sand or heat sources caused by
heating equipment or direct sunlight.
•
Allow a sufficient amount of free space all around the SL400i for adequate ventilation.
•
Do not open this product. Contact your Philips retailer if you experience technical
difficulties.
•
Place the system on a flat, hard and stable surface. When the system is switched to
standby mode, it is still consuming some power.To disconnect the system from the power
supply completely, remove the AC power plug from the wall outlet.
•
Make sure the air around the SL400i can circulate to prevent the SL400i from overheating
internally. Also, avoid putting any heat sources (e.g. a power amplifier) underneath.
The SL400i has a thermal shutdown that shuts down the set when the internal
temperature exceeds a certain threshold. If this happens, the set switches to standby with
the Power-LED flashing on and off.To remedy this situation: disconnect the mains, let the
set cool down, improve ventilation, and reconnect the set to the mains.