1
Insert the cassette into the cassette slot.
v
appears in the
display.
2
Playback:
Press the playback button
PLAY
G
.
3
Picture scanning:
Press the
H
(reverse) or
I
(for-
ward) button once or several times. You have a choice of
several picture scanning speeds.
4
Interrupt:
Press the
STOP
h
button.
5
Wind and rewind:
Interrupt the playback function with the
STOP
h
button and press the
H
(rewind) or
I
(wind) button. In the display appears:
0:20
If, during wind/rewind, you want to have a quick access to
picture scanning, use the ’Instant View’ function.
6
Instant View:
If you hold the
H
(rewind) or
I
(wind)
button during wind or rewind, you will switch to picture
scanning. If you release the button, the video recorder will
automatically switch back to rewind or wind again.
7
Eject a cassette:
Interrupt the playback function with the
STOP
h
button and press the
STOP/EJECT
?
button on
the video recorder.
Notes:
Some functions switch off automatically after a while
(e.g.: pause, still picture, picture scanning). This helps to
protect the cassette and prevent unnecessary power
consumption.
* The picture quality will deteriorate during picture scan-
ning. The sound is turned off.
Still picture
1
Press the
STILL
R
button. You see a still picture. Inter-
ference stripes will appear on the screen.
2
Each time you press
STILL
R
again, the picture will
move on one step.
Note:
If the still picture vibrates vertically, hold the
P
r
or
the
P
q
button at step
1
until the vibration is minimal.
This setting will be stored automatically.
Please note, however, that interference may still occur with
poor quality cassettes.
Tape position/Index search
Tape position:
The elapsed playback time, given to the hour
and minute, appears in the display.
When you load a cassette, the video recorder must first
calculate the playing time. Therefore, ’-:--’ appears first and
only after the tape has been running for a few seconds the
playing time will be shown.
The playback time displayed can be incorrect when using
camcorder cassettes or with cassettes made for NTSC-VHS
equipment.
Index search:
At the beginning of each recording, the video
recorder marks the tape with a code mark. You can search for
these code marks on the tape. Once the video recorder finds
the code mark or a blank space, it will automatically switch to
playback.
1
To select the next or the previous code mark, press the
INDEX
E
button and then press the
I
or the
H
but-
ton.
Note:
You cannot use the function ’Index search’ with
recordings made on another video recorder that does not
have this code mark function.
2.
PLAYBACK FUNCTIONS
6
