1
2
3
5
!
9
6
0
7
8
4
—
22 —
O
PERATING
T
V
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
You can use this remote control to operate your
TV, not only PHILIPS TV but also other
manufacturer’s TVs listed below.
You first need to set the manufacturer’s code.
Note:
Though this remote control can operate most of the
PHILIPS TVs as well as many other manufacturers’,
some of the TVs will not operate or some functions
available on the TVs will not work with this remote
control.
1
Set Code
1 Press and hold
TV
.
2 Press
two Number
buttons for the manufac-
turer’s code number of your TV, referring to
the table to the right.
• For example, for 02, press
0
then
2
.
3 Press
STOP
7, then release
TV
.
• The remote control can now operate the TV of
the selected code.
2
Confirm Setting
Press
POWER
f
, pointing the remote control at
the TV.
If the TV turns on or off, your setting is com-
pleted.
If not, repeat steps above, using another code.
TV Manufacturers’ Codes
PHILIPS
01, 02, 03
EMERSON
14
GOLDSTAR
04
GRUNDIG
24, 25
HITACHI
12
JVC
05
MITSUBISHI
13, 26
PANASONIC
07, 17, 19, 20
RCA
10
SAMSUNG
18
SANYO
11
SHARP
16
SONY
09
THOMSON
21, 22, 23
TOSHIBA
08
ZENITH
06, 15
The buttons on the remote control which you can
use to operate your TV are shown above;
1
TV: Makes the remote control ready
for operating the TV. Make sure
you press this button before
pressing the other operative buttons.
2
POWER
f
: Turns the TV on or off.
3
VCR/TV: Selects TV mode or Auxiliary
mode at TV.
4
ALT/SPEED (for PHILIPS TV only): Goes
back to the previously selected channel on
TV.
5
VOL
5
5
5
5
5 ∞
∞
∞
∞
∞ : Changes the TV volume.
6
CH
5
5
5
5
5 ∞
∞
∞
∞
∞ : Changes the TV channels.
7
5
5
5
5
5 ∞
∞
∞
∞
∞
; :
(for PHILIPS TV only): Operates
the TV menu.
8
MENU (for PHILIPS TV only): Operates
the TV menu.
9
OK/STATUS - For PHILIPS TV : Displays
the on-screen information.
For some other manufac-
turer's TV; functions as an
ENTER button after pressing
the number buttons while
selecting channels.
0
AUDIO/MUTE: Turns off the TV sound.
!
NUMBER BUTTONS: To select channels.
After replacing the batteries
You need to reset the manufacturer’s code again.
220/75
01.5.11, 4:17 PM
22
