8
Installation Instructions
Before you Begin
The controller is intended for indoor use only.
Protect the controller from direct sunlight and place it in a dry
environment.
The controller and battery must be installed in the same room.
The controller warms up during operation; be sure it is installed on a
non-flammable surface.
Connect the Controller
Please verify that all the cable/wire connections are made properly
and well insulated so that no water or humidity can get in. This
avoids any bad or loose connections that would result in excessive
heating or further damage.
1. *Connect the battery to the charge controller; Positive
(+) & Negative (-).
2. Connect the solar modules to the charge controller;
Positive (+) & Negative (-).
3. Connect the load to the charge controller; Positive (+)
& Negative (-).
*Phocos strongly recommends installing an inline fuse as
close to the battery terminal as possible.
See illustrated steps on opposite page.
Summary of Contents for 321665
Page 1: ...1 ECO N T User Manual www phocos com...
Page 9: ...9 Tech Data...
Page 17: ...17 Datos T cnicos...
Page 25: ...25 Donn es Techniques...
