Never work on live (energized) electrical equipment.
When working around a battery, do not allow tools to bridge the battery terminals, or short circuit any part of the battery.
Use only tools with insulated handles.
Operation of this device may produce a high voltage which could cause severe injuries or death in case of improper installation or operation of the
device.
PV modules can generate high DC voltages!
Mains and charging current risks
Make sure the cables are always connected to the correct terminal. An electrical shock c an be lethal. In general, any electric shock can be dangerous
to your health.
CE labeling
The product is CE compliant.
Connecting and Grounding
The controller is intended for indoor use only. Protect it from direct sunlight and place it in a dry environment. Never install it in humid rooms (like
bathrooms). The controller warms up during operation, and should therefore be installed on a non flammable surface only.
Connect wires in indicated order 1 2 3 4 5 6 to avoid any installation faults
To avoid any damaging voltage on the wires, first connect the wire to the controller, then to the battery, to the panel or to the load
Minimum recommended wire size: 4 mm²
Make sure the wire length between battery and controller is as short as possible
Be aware that the negative terminals of the ECO-N-MPPT 85/15 are connected together and therefore have the same electrical potential. If any
grounding is required, always do this on the negative wires.
When connecting inductive loads (motors, relays, etc.) a freewheel diode must be connected in parallel to the loads in the reverse biased
direction.
Inverters should always be connected directly to the battery due to their high inrush currents.
The MXI communication cable can optionally be used together with a Phocos MXI or MXI232 accessory, sold separately.
The temperature sensor cable should be left hanging on the charge controller to accurately measure the ambient temperature, but not touching the c
harge controller at its end.
12
Summary of Contents for ECO-N-MPPT 85/15
