Operating the CUTFOX 10
102786_en_03
PHOENIX CONTACT
11
English
2.4
Automatic cable cutting
The CUTFOX 10 cuts the amount entered automatically to a specified length. This is the
default mode and is active when the machine is switched on.
•
Switch on the CUTFOX 10.
•
Insert the cable as described (see page 10).
•
To switch into this mode, press the "mode" button and then the "1" key.
Entering the parameters
•
Enter the length and number of cuts with the keys "0" to "9".
•
You can overwrite the values or delete them with the "C" button.
•
For entries in inches, decimal places can be used.
•
Switch to the next line with the "enter" key.
Cutting the cable
•
Press the "start" button. The green LED lights up.
The cable is then cut automatically.
Pausing or stopping the
cable
•
Cutting can be interrupted. To do this, press the "stop" button. The red "stop" LED
flashes.
•
Press the "start" button to continue cutting.
•
If you would like to stop cutting, press and hold the "stop" button for at least two sec-
onds. The To go display is set to "0000".
Cutting finished
When the cutting is completed, the To go display reads "0000" and a checkmark is shown.
The length and number can be re-entered.
Changing modes
•
Press the "mode" button to switch back to mode selection.
Length (mm or inch, see page 10)
Number of cuts
To go (Number of cuts remaining)
