Troubleshooting
102786_en_03
PHOENIX CONTACT
19
English
3.6
Replacing the cutters
Removing the drive rollers
•
Press the door opener and fold down the front door.
•
Insert the removal hook (1) supplied behind the rollers
(2) and push off the rollers.
Removing the cutters
•
Loosen the screws (1) with the Allen key supplied.
•
Remove both cutters (2 and 4).
Mounting the cutters
•
Place the lower blade (4) with the threaded insert onto
the holder from the right.
•
Place the upper blade (2) onto the holder from the left.
•
Tighten the screws with the Allen key.
•
Remount the drive rollers.
•
Fold up the front door.
•
Plug in the mains plug again.
WARNING: Risk of injury
Switch off the CUTFOX 10 and disconnect the
mains plug.
NOTE:
Always replace both cutters.
Pay attention when mounting that the slanted
cutting surfaces (3) face outwards.
NOTE:
Pay attention to the position of the flat
guide surfaces on the shafts (5) when mounting
the rollers.
