CUTFOX 10
14
PHOENIX CONTACT
102786_en_03
2.6
Manual cable cutting
The cable can be moved and cut using button commands.
•
Insert the cable as described (see page 10).
•
Switch on the CUTFOX 10.
•
To switch into this mode, press the "mode" button and then the "3" key.
Cutting cable
•
Press and hold the "6" key until the cable has been moved the desired length.
•
Press the "2" key to cut the cable.
Deleting the length
•
Press the "C" key to delete the set length.
Changing modes
•
Press the "mode" button to switch back to mode selection.
2.7
Exiting from cutting
•
When no more cable is to be cut, switch off the mains switch (press 0).
•
Open the front door and remove the cable.
Length moved (mm or inch, see page 10)
Cutting
