onlinecomponents.com
IB IL 24/230 DOR 1/W
2
5663BC01
Safety Notes for Inline Terminals Used in Areas Outside the
SELV (AC Area)
Only qualified personnel may carry out work on
the Inline terminals of the AC area.
Qualified personnel are people who, because of
their education, experience and instruction and
their knowledge of relevant standards,
regulations, accident prevention and service
conditions, have been authorized by those
responsible for the safety of the plant to carry out
any required operations and who are able to
recognize and avoid any possible dangers.
(Definitions for skilled workers according to
EN 50110-1:1996).
The instructions given in this data sheet and
in the IB IL SYS PRO UM E User Manual must
be followed during installation and startup.
Technical modifications reserved.
Correct Usage
The terminal is only to be used within an Inline
station as specified in this data sheet and the
INTERBUS Inline System Manual. Phoenix
Contact accepts no liability if the device is used
for anything other than its designated use.
Dangerous voltage!
Dangerous voltage when switching
current circuits that do not meet the
requirements of the SELV.
Connecting and disconnecting the AC
terminals is only allowed if the power
supply is disconnected.
When working on the terminals and
wiring, always switch off the supply
voltage and ensure it cannot be
switched on again.
For general information on the
INTERBUS Inline product range,
please refer to the “Configuring and
Installing the INTERBUS Inline
Product Range” User Manual
IB IL SYS PRO UM E.
