5756B
13
Connect the controller board to the PLC power supply
unit. In this case, the controller board will also be reset
on a PLC POWER-UP.
Inserting the Parameterization Memory
Please note that only the test mode enables the
operation of the controller board without
parameterization memory. During normal operation a
parameterization memory must be inserted.
Figure 14
Inserting the parameterization memory
Inserting the Parameterization Memory
Insert the parameterization memory into the slot provided,
with the female connector to the front (see Figure 14). Make
sure that when the parameterization memory is pressed
lightly it clicks into place and the ejector moves out.
As you insert the parameterization memory, make
certain that the card is located in the guide rails on
both sides of the card holder. Make sure that the
parameterization memory is properly aligned.
Removing the Parameterization Memory
Press the ejector. The parameterization memory will be
ejected from the slot. You can then remove it from the front.
5 7 5 6 A 0 1 5
